Would like to specify prism Growth Ratio AND first cell height for accurate initial guess for BL capture - Project Support - SimScale CAE Forum

Hi, I am doing a CFD simulation of a F1 rear wing design I’ve quickly knocked up in NX. With this kind of simulation I’ve read it is very important to make sure your mesh accurately captures the boundary layer, especially when dealing with large pressure gradients and wanting to check for/where flow seperation occurs. Since I’m using SST turbulence model, I know I want to be aiming for y+ value of around 1. And from other reading, ideally I would want at least 25-30 prism layers, however, max S

Prism 9: Taking your analyses and graphs to higher dimensions

A voxel-based clump generation method used for DEM simulations

Boundary Layer Does Not Form - Except When Default Settings Used - Project Support - SimScale CAE Forum

1540 questions with answers in COMPUTATIONAL FLUID DYNAMICS

Prism layer still displaying jumps? (STARCCM+) : r/CFD

Spatiotemporal single cell analyses reveal a transient population of retinal progenitor cells in the ciliary margin of developing human retina - Abstract - Europe PMC

Hands-on: Inferring single cell trajectories (Monocle3) / Single Cell

CoLi-BA: Compact Linearization based Solver for Bundle Adjustment

Prism layer still displaying jumps? (STARCCM+) : r/CFD

Prism layer still displaying jumps? (STARCCM+) : r/CFD

Boundary Layer Does Not Form - Except When Default Settings Used - Project Support - SimScale CAE Forum

Adaptive step size algorithm to increase efficiency of proton macro Monte Carlo dose calculation, Radiation Oncology

Force and momentum coefficients - Project Support - SimScale CAE Forum

A hybrid mesh and voxel based Monte Carlo algorithm for accurate and efficient photon transport modeling in complex bio-tissues