Z Compression Correction? - Form 3/3+ - Formlabs Community Forum

I’m printing directly on the build platform (V2) and am having trouble getting the height of the parts close to size. I started with the default settings and my part came out 0.9mm too high. I adjusted the z compression correction to 0.0mm and my part is still 0.2mm too high. How to I adjust it further to compensate? Also, how do I avoid the edge highlighted in the second image where the part sits on the build plate? Thanks. (I’m printing directly on the platform for speed of print and surfac

Form 3 vs. Form 2 Faceoff! - Form 3/3+ - Formlabs Community Forum

DDL2021 Digital Proceedings by info-ddl-conference - Issuu

marrs

Orientation of large flat parts - General Discussion - Formlabs Community Forum

Z-Compression Correction question - General Discussion - Formlabs Community Forum

First Layher Exceeding base Problem - Support & Troubleshooting - Formlabs Community Forum

Three-dimensional architecture and assembly mechanism of the egg-shaped shell in testate amoeba Paulinella micropora - Frontiers

s41205-023-00197-5, PDF, Young's Modulus

s41205-023-00197-5, PDF, Young's Modulus

Printing on build platform - General Discussion - Formlabs Community Forum

Glazing of 3D-Printed Silica to Reduce Surface Roughness and Permeability

Uncategorized