AN316 Thin Jam Nut (Non-Locking Check Nut)

Use Military Specification AN316 thin jam nuts to lock down adjusting screws or to prevent rotation of components threaded only partway into a female part (such as rod ends).

This 3mm axle key is mainly used for rear wheel hub placement on Margay racing karts.

Margay 3 mm Axle Key with Drive Pegs

Wag-Aero AN363-1032 All metal stop nuts - AN363 All Metal Stop

Nuts - Jam Thin Nuts - BelMetric

This M7x1.0 plain jam nut is used on the throttle shaft of Weber DCOE (including 48 DCO), DCNF, IDF; and IDA (Dual) carburetors. It is also used as a

Weber DCOE, IDA, IDF Throttle Shaft Nut

This steel brake adapter has a male 3/8-24 inverted flare (concave) fitting on one end and a 4AN male (7/16-20, 37° convex) on the other end. The

4AN/42 degree Inverted Flare 3/8-24 Brake Adapter-Short

These pushrods will fit Girling master cylinders with integral or remote reservoirs (our Part No. 3500-Size and 3502-Size). The 3.3 long pushrod has

Pushrod, Girling Master Cylinder, 5/16-24 thread

Two of these clips hold the Throw Out Bearing to the clutch release cross shaft on Hewland and Webster Mk-series gearboxes. Not used with hydraulic

Retaining Clip for Throw Out Bearing

Wide Series Swaged Bearing Proof Cups Kit - Pegasus Auto Racing

AVIATIONEU NEW ERA AN316/NASM316 Series Hex Thin Non-Locking Jam

Aircraft Nuts

$0.60 Each, hexagon jam nut 1/4-28 thread left

Plain Hexagon Nut

AN316-6L, AN Nuts, AN Nuts

This is the same jam nut included with the Tilton 7/16-20 Brake Bias Bar (Part No. TE 72-260). It will also work on most other brands with 7/16-20

Tilton Jam Nut 7/16 inch for Brake Balance Bar Assembly